Msi MS-9638 series Manual do Utilizador Página 75

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 81
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 74
C-4
MS-9638 Server Board
Configure/View SCSI Settings
SCSI Bus Interface Definitions
SCSI Controller ID
The item is used to assign a SCSI ID to the SCSI controller. It is recommended that you
should leave the default setting unchanged. Settings: [0] ~ [15].
SCSI Controller Parity
Use the field to enable or disable SCSI parity error checking function. If any of your
SCSI devices does not support parity checking, disable this function. While disabling
the function, you should disable disconnections for all devices, as parity checking for
the reselection phase is NOT disabled. A non-parity devices I/O operation will never
complete if the reselection fails due to a parity error.
SCSI Controller Termination
In order to have the SCSI bus function properly and reliably, termination at the ends of
the SCSI bus is necessary. Proper termination can ensure signal on the SCSI bus will
not reflect and cause data loss or errors. Settings options: [Enabled], [Disabled].
There are 8 items in the Configure/View SCSI Controller Settings screen. These
items display or allow you to change the SCSI controllers settings. Use the arrow
keys to highlight the item and then press <Enter> to select the value you want in each
item or enter each items sub-menu screen.
AIC-7901 at slot 00, 05:05:00
SCSI Bus Interface Definitions
SCSI Controller ID....................................7
SCSI Controller Parity.............................Enabled
SCSI Controller Termination..................Enabled
Additional Options
Boot Device Configuration.....................Press <Enter>
SCSI Device Configuration......................Press <Enter>
Advanced Configuration..........................Press <Enter>
HostRAID...................................................Enabled
<F6> -- Reset to SCSI Controller Defaults
Configuration
Interrupt (IRQ) Channel..........................11
I/O Port Address........................................B000h, B400h
BIOS Information
9638v1.0-Appendix C(SCSI BIOS).p65 2006/11/9, 下午 03:334
Vista de página 74
1 2 ... 70 71 72 73 74 75 76 77 78 79 80 81

Comentários a estes Manuais

Sem comentários